Steps
1. Align and place the touchpad along with the touchpad flexible flat cable into its slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) to secure the touchpad to the palm-rest and keyboard assembly.
3. Connect the touchpad flexible flat cable to the connector on the system board.
4. Place the touchpad bracket on the touchpad.
5. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
6. Replace the three screws (M2x2) to secure the touchpad bracket to the palm-rest and keyboard assembly.
7. Connect the hard-drive flexible flat cable to the connector on the system board.
Next steps
1. Install the 3-cell battery or the 4-cell battery, whichever applicable.
2. Install the base cover.
3. Install the secure digital card.
4. Follow the procedure in After working inside your computer.
Removing and installing components
41
To Next Page
Loading...
