Steps
1 Loosen the three captive screws on the base cover.
2 Remove the four screws (M2x6) that secure the base cover to the palm-rest and keyboard assembly.
3 Pry the base cover starting from the top-left corner of the palm-rest and keyboard assembly.
4 Lift the base cover o the palm-rest and keyboard assembly.
Installing the base cover
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the base cover and provides a visual representation of the installation procedure.
Removing and installing components
11
To Next Page
Loading...
