6 Replace the two screws (M2.5x3.5) that secure the left display hinge to the I/O board and palm-rest and keyboard assembly.
Next step
1 Install the fan.
2 Install the battery.
3 Install the base cover.
4 Follow the procedure in After working inside your computer.
Power-button board
Removing the power-button board
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the WLAN card.
5 Remove the fan.
6 Remove the I/O board.
About this task
The following image indicates the location of power button and provides a visual representation of the removal procedure.
Steps
1 Remove the screw (M1.6x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
2 Remove the screw (M1.6x2) that secures the power-button board to the palm-rest and keyboard assembly and lift the power-button
board o the palm-rest and keyboard assembly.
42
Removing and installing components
To Next Page
Loading...
