5 Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
6 Lift the I/O board oî the palm-rest and keyboard assembly.
Installing the I/O board
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of I/O board and provides a visual representation of the installation procedure.
Steps
1 Align and place the I/O board on the palm-rest and keyboard assembly.
2 Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
3 Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
4 Adhere the tape that secures the I/O board to the I/O board.
5 Using the alignment posts, close the display hinges.
Removing and installing components
41
To Next Page
Loading...
