Steps
1 Place the computer with the hinges facing towards you.
2 Align the base cover on the palm-rest and keyboard assembly, and snap the base cover into place.
3 Replace the four screws (M2x6) that secure the base cover to the palm-rest and keyboard assembly.
4 Tighten the three captive screws that secure the base cover to the palm-rest and keyboard assembly.
Next step
1 Follow the procedure in After working inside your computer.
Battery
Removing the battery
Prerequisite
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
About this task
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
12
Removing and installing components
To Next Page
Loading...
