Steps
1 Peel the tapes that secure the touchpad to the palm-rest and keyboard assembly.
2 Open the latch and disconnect the touchpad cable from the system board.
3 Remove the three (M1.6x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
4 Lift the touchpad bracket o the palm-rest and keyboard assembly.
5 Remove the two (M1.6x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
6 Lift the touchpad, along with the cable, o the palm-rest and keyboard assembly.
Installing the touchpad
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of touchpad and provides a visual representation of the installation procedure.
Removing and installing components
31
To Next Page
Loading...
