Dell Inspiron 5390 - Installing the Display Hinges; Camera

3 Lift the display hinges o the display back-cover.
Installing the display hinges
Prerequisite
NOTE: This procedure is not applicable to computers shipped with a WWAN conguration.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of display hinges and provides a visual representation of the installation procedure.
Steps
1 Align the screw holes on the hinges with the screw holes on the display back-cover.
2 Replace the two (M2x2) screws that secure the display hinges to the display back-cover.
3 Replace the four (M2.5x2.5) screws to secure the display hinges to the display back-cover.
Next step
1 Install the display bezel.
2 Install the display assembly.
3 Install the WLAN card.
4 Install the battery.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
Camera
56
Removing and installing components