4 Note the routing of the speaker cable and remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.
NOTE: Note the position of the rubber grommets before lifting the speakers.
5 Lift the speakers, along with the cable, o the palm-rest and keyboard assembly.
Installing the speakers
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of speakers and provides a visual representation of the installation procedure.
Steps
1 Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
2 Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3 Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4 Connect the speaker cable to the system board.
26
Removing and installing components
To Next Page
Loading...
