Dell Inspiron 5390 - Removing the Camera; Installing the Camera

Removing the camera
Prerequisites
NOTE: This procedure is not applicable to computers shipped with a WWAN conguration.
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the WLAN card.
5 Remove the display assembly.
6 Remove the display bezel.
7 Remove the display panel.
About this task
The following image indicates the location of camera and provides a visual representation of the removal procedure.
Steps
1 Peel the tape that secures the camera to the display back-cover
2 Using a plastic scribe, pry the camera from the alignment post on the display back-cover.
3 Turn over the camera and disconnect the camera cable o the camera.
4 Peel the tape o the camera and lift the camera o the display back-cover.
Installing the camera
Prerequisite
NOTE
: This procedure is not applicable to computers shipped with a WWAN conguration.
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
57