Installing the power-button board
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of power-button board and provides a visual representation of the installation procedure.
Steps
1 Align the screw hole on the power-button board with the screw hole on the palm-rest and keyboard assembly.
2 Replace the screw (M1.6x2) that secures the power-button board to the palm-rest and keyboard assembly.
3 Align the screw hole on the power-button bracket with the screw hole on the palm-rest and keyboard assembly.
4 Replace the screw (M1.6x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
Next step
1 Install the I/O board.
2 Install the fan.
3 Install the WLAN card.
4 Install the battery.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
Power button with ngerprint reader
Removing and installing components
43
To Next Page
Loading...
