Dell Inspiron 5390 - Page 36

Steps
1 Remove the screw (M2.5x3.5) that secures the display-cable bracket to the system board.
2 Lift the display-cable bracket o the system board.
3 Using the pull tab, disconnect the display cable from the system board.
4 Remove the two screws (M2.5x3.5) that secure the left display hinge to the I/O board and palm-rest and keyboard assembly.
5 Remove the screw (M2x4) that secures the right display hinge to the system board.
6 Open the display hinges at an angle of 90 degrees.
7 Remove the palm-rest and keyboard assembly o the display assembly.
36
Removing and installing components