Steps
1 Using a plastic scribe, slide out the pull tab of the SR tape from both sides of the display panel.
2 Pull out a small section of the SR tape.
3 Roll the SR tape around the plastic scribe.
NOTE
: To avoid severing/breaking the SR tape, pull out only a small section of the SR tape and then roll the SR tape
around the scribe.
4 Lift the display panel o the display back-cover.
5 Peel the tape that secures the display cable to the display back-cover.
6 Open the latch and disconnect the display cable from the display back-cover.
52
Removing and installing components
To Next Page
Loading...
