c. Release the cables from the placeholders [3].
d. Remove the screw that secures the power and volume control board to the computer [4].
e. Lift the power and volume control board away from the computer [5].
Installing the power and volume control board
1. Place the power and volume control board into the slot on the computer.
2. Tighten the screw to secure the power and volume control board to the computer.
3. Align the cables through the placeholders.
4. Connect the power and volume control board to the connector on the system board.
5. Affix the adhesive tape to secure it.
6. Install the:
a. battery
b. base cover
7. Follow the procedure in After working inside your computer.
18
To Next Page
Loading...
