4. To remove the LED board:
a. Lift the latch and disconnect the LED board cable [1].
b. Release the LED board cable from the computer [2].
c. Peel the adhesive tape to access the LED board [3].
d. Lift the LED board away from the computer [4].
Installing the LED board
1. Place the LED board into the slot on the computer.
2. Affix the adhesive tape to secure the LED board to the computer.
3. Affix the LED board cable and connect the LED board cable to the connector.
4. Install the:
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
29
To Next Page
Loading...
