Installing the display cable
1. Route the display cable through the placeholders on the display panel.
2. Align the display cable along the routing channels on the display panel.
3. Connect the display cable and sensor board cable to the connectors on the display panel.
4. Affix the adhesive tapes to secure the display cable and sensor board cable.
5. Install the:
a. display cover
b. display assembly
c. battery
d. base cover
6. Follow the procedure in After working inside your computer.
Sensor board
Removing the sensor board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. display assembly
d. display cover
3. To remove the sensor board:
a. Remove the screw that secures the sensor board to the display panel [1].
b. Peel the adhesive tape that secures the sensor board cable [2].
c. Open the latch and disconnect the sensor board from the display panel [3].
d. Lift the sensor board away from the display panel [5].
42
To Next Page
Loading...
