Installing the Input/Output (I/O) board
1. Place the I/O board into the slot on the computer.
2. Tighten the screws to secure the I/O board to the computer.
3. Connect the coin cell battery and power and volume button board cables to the connector on the
I/O board.
4. Connect the I/O board cable to the connector on the I/O board.
5. Affix the adhesive tape to secure the I/O board cable
6. Install the:
a. battery
b. base cover
7. Follow the procedure in After working inside your computer.
Power connector
Removing the power connector port
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the power connector port:
a. Disconnect the power connector port cable from the connector on the system board [1].
b. Remove the screw that secures the power connector port to the computer [2].
c. Lift the power connector port away from the computer [3].
31
To Next Page
Loading...
