Installing the solid state drive (SSD) card
1. Connect the SSD card to the connector on the system board.
2. Tighten the screw to secure the SSD card to the computer.
3. Install the:
a. battery
b. base cover
4. Follow the procedure in After working inside your computer.
Coin cell battery
Removing the coin cell battery
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the coin cell battery:
a. Disconnect the coin cell battery from the connector on the system board [1].
b. Pry the coin cell battery to remove it from the computer [2].
20
To Next Page
Loading...
