Installing the touchpad
1. Place the touchpad on the computer.
2. Tighten the screws to secure the touchpad to the computer.
3. Place the metal tab over the touchpad.
4. Tighten the screws to secure the metal tab.
5. Connect the touchpad cable and keyboard daughter board cable to the connectors on the system
board.
6. Install the:
a. battery
b. base cover
7. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. WLAN card
3. To release the display assembly:
a. Peel the adhesive tapes that secure the display cable and touch screen board cables [1] [2].
b. Open the latches and disconnect the display and touch screen board cables from the system
board [3] [4].
37
To Next Page
Loading...
