Installing the speakers
1. Place the speakers into the slots on the computer.
2. Route the speaker cable through its routing channel.
3. Connect the speaker cable to the connector on the system board.
4. Install the:
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
Touchpad panel
Removing the touchpad
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. Remove the two M2x2 screws that secures the touchpad bracket to the system [1].
4. Peel off the adhesive tape that secures the touchpad bracket [2].
36
Disassembly and reassembly
To Next Page
Loading...
