5. Route the display cable through the routing channel on the system fan and the clip on the system, and connect the display
cable to its connector on the system board.
NOTE: Display cable should be routed above the WWAN antennas (for models shipped with a WWAN card), and then
secured with conductive tape on the palm rest.
6. Install the:
a. Installing the WWAN daughterboard on page 20
b. Installing the WLAN card on page 19
c. hard drive
d. battery
e. base cover
7. Follow the procedure in After working inside your computer
System board
Removing system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. M2. SSD
d. hard drive
e. fan
f. WLAN card
g. WWAN card
h. display assembly
3. Disconnect the following cables and connectors:
a. VGA cable [1]
b. Unroute the VGA cable from the routing channel [2]
c. Speaker cable connector [3]
d. DC-in cable [4]
Disassembly and reassembly
41
To Next Page
Loading...
