9. Remove the Coin cell battery.
10. Remove the Inner frame.
Steps
1. Disconnect and peel the USH daughter board Flexible Flat Cable (FFC) from the USH daughter board [1, 2].
2. Disconnect the LED board cable from the connector on the system board.
3. Unroute the LED board cable [2].
4. Peel the grey adhesive tape that secures the LED board [2].
5. Remove the single (M2x2.5) screw that secures LED board to the palmrest [1].
6. Lift the LED board away from the computer [2].
Onderdelen verwijderen en plaatsen
47
To Next Page
Loading...
