Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Place the battery on the palmrest and align the screw holes on the battery with the screw holes on the palmrest.
2. Install the single (M2x6) captive screw to secure the battery to the palmrest.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
24
Disassembly and reassembly
To Next Page
Loading...
