About this task
The figure indicates the location of the power button with fingerprint and provides a visual representation of the installation procedure.
Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to the palmrest.
Next steps
1. Install the system board.
NOTE:
System board can be installed with heatsink attached.
2. Install the DC-in.
3. Install the LED board.
4. Install the inner frame.
5. Install the memory.
6. Install the WLAN card.
7. Install the WWAN card.
8. Install the 2280 SATA SSD.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the WWAN card.
66
Disassembly and reassembly
To Next Page
Loading...
