Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the coin-cell and provides a visual representation of the installation procedure.
Steps
1. Locate the coin-cell battery slot on your computer.
2. Adhere the coin-cell battery on to the slot.
3. Connect the coin-cell cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Inner frame
Removing the inner frame
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the 2280 SATA SSD.
5. Remove the WLAN card.
6. Remove the WWAN card.
Disassembly and reassembly
33
To Next Page
Loading...
