Steps
1. Locate the touchpad button board slot on your computer.
2. Align and place the touchpad button board into the slot on your computer.
3. Replace the two (M2x3) screws to secure the touchpad button board to the plamrest.
4. Connect the touchpad button board cable to the connector on the system board and secure the latch.
Next steps
1. Install the inner frame.
2. Install the WLAN card.
3. Install the WWAN card.
4. Install the 2280 SATA SSD.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
LED board
Removing the LED board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the 2280 SATA SSD.
5. Remove the WLAN card.
6. Remove the WWAN card.
Disassembly and reassembly
51
To Next Page
Loading...
