7. Remove the inner frame.
About this task
The figure indicates the location of the LED board and provides a visual representation of the removal procedure.
Steps
1. Locate the LED board on your computer.
2. Open the latch and disconnect the LED board cable from the connector on the system board.
3. Peel back the LED board cable.
NOTE:
The LED board cable is secured to the computer by an adhesive strip.
4. Remove the single (M2x3) screw that secures the LED board to the computer.
5. Lift the LED board out of the computer.
Installing the LED board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the LED board and provides a visual representation of the installation procedure.
52
Disassembly and reassembly
To Next Page
Loading...
