Steps
1. Locate the smartcard reader board on your computer.
2. Open the latch and disconnect the touchpad button board cable from the system board.
3. Open the latch and disconnect the smartcard reader board cable from the system board.
4. Peel the smartcard cable from the palmrest.
5. Remove the three (M2x3) screws that secure the smartcard reader board to the computer.
6. Lift the smartcard reader module out of the computer.
Installing the smartcard reader board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the smartcard reader board and provides a visual representation of the installation procedure.
Steps
1. Locate the smartcard reader board slot on your computer.
48
Disassembly and reassembly
To Next Page
Loading...
