Dell Latitude 5401 - Display Hinges; Removing Display Hinge

Steps
1. Insert the camera into the slot on the display back cover .
2. Connect the camera cable to the connector and adhere the adhesive tape above the camera connector.
3. Affix the two conductive tape above the camera module.
Next steps
1. Install the display panel.
2. Install the display hinge caps.
3. Install the display bezel.
4. Install the display assembly.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Display hinges
Removing display hinge
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinge caps.
7. Remove the display panel.
About this task
The figure indicates the location of the camera and provides a visual representation of the removal procedure.
84
Disassembly and reassembly