Removing intrusion switch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Back cover
b Front bezel
3 Open the Front panel door.
4 To the intrusion switch:
a Disconnect the intrusion switch cable from the connector on the system board [1].
b Un-route the intrusion switch cable from the cable holder.
c Slide the intrusion switch and push it to remove from the computer [2].
Installing intrusion switch
1 Insert the intrusion switch into the slot on the computer.
2 Route the intrusion switch cable through the cable holder.
3 Connect the intrusion switch cable to the connector on the system board.
4 Close the front panel door.
30
Disassembly and reassembly
To Next Page
Loading...
