Installing the optional VGA module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the installation
procedure.
Figure 81. Installing the optional VGA module
Steps
1. Using a screwdriver, remove the optional-module cover from the chassis.
NOTE: This step is applicable only when the optional VGA module is being installed for the first time.
NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis.
2. Insert the optional VGA module in the slot on the chassis.
3. Connect the VGA module cable to the connector (VIDEO) on the system board .
4. Replace the two screws (M3) to secure the optional VGA module to the chassis.
Removing and installing Field Replaceable Units (FRUs)
105
To Next Page
Loading...
