NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis.
2. Insert the optional HDMI module in the slot on the chassis.
3. Connect the optional HDMI-module cable to the connector (VIDEO) on the system board .
4. Replace the two screws (M3X3) to secure the optional HDMI module to the chassis.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Optional DisplayPort module
Removing the optional DisplayPort module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the optional DisplayPort module and provide a visual representation of the removal
procedure.
Figure 78. Removing the optional DisplayPort module
Steps
1. Remove the two screws (M3X3) that secure the optional DisplayPort module to the chassis.
2. Disconnect the optional DisplayPort-module cable from the connector (VIDEO) on the system board.
102
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
