Figure 47. Removing the intrusion switch
Steps
1. Disconnect the intrusion-switch cable from the connector (INTRUSION) on the system board.
2. Remove the intrusion-switch cable from the retention clips on the chassis.
3. Slide the intrusion switch to the unlocked position and remove the intrusion switch from the chassis.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the installation
procedure.
72
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
