Optional I/O modules
Optional serial module
Removing the optional serial module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the optional serial module and provide a visual representation of the removal
procedure.
Figure 70. Removing the optional serial module
Steps
1. Remove the two screws (M3) that secure the optional serial module to the chassis.
2. Disconnect the optional serial module cable from the connector (KB MS SERIAL) on the system board.
3. Slide the optional serial module out of the port opening and lift the optional serial module off the system board.
Installing the optional serial module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
95
To Next Page
Loading...
