Figure 30. Installing the Dell Ultra Speed Drive Gen3 card
Steps
1. Place the Dell Ultra Speed Drive Gen3 card on a clean and flat surface.
2. Slide the solid-state drive at an angle in the connector on the Dell Ultra Speed Drive Gen3 card.
3. Align and place the standoff nut in the notch on the solid-state drive.
4. Carefully turn the Dell Ultra Speed Drive Gen3 card such that the solid-state drive faces down.
5. Replace the screw (M2x5) to secure the solid-state drive to the Dell Ultra Speed Drive Gen3 card.
6. Lift the pull tab on the PCIe door outwards to open the PCIe door.
7. Remove the PCIe blanking plate from the slot on the chassis.
NOTE: Ensure to keep the PCIe blanking plate safe for future use.
8. Align the notch on the Dell Ultra Speed Drive Gen3 card with the tab on the PCIe card connector (SLOT3) on the system
board.
9. Gently press down on the Dell Ultra Speed Drive Gen3 card till the tab on the PCIe connector locks in place.
10. Close the PCIe door and press it gently until it clicks in place on the chassis, to secure the Dell Ultra Speed Drive Gen3 card.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
External puck antenna
Computers that are shipped with Intel Wi-Fi 6E AX211 wireless card come with an external puck antenna installed.
For more information about the installation procedure of external puck antenna for your computer, see OptiPlex Antenna
Installation Guide on the documentation support page of OptiPlex Tower 7020.
Removing and installing Customer Replaceable Units (CRUs)
55
To Next Page
Loading...
