4. Replace the two screws (M3X3) to secure the optional DisplayPort module to the chassis.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Optional VGA module
Removing the optional VGA module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the removal
procedure.
Figure 80. Removing the optional VGA module
Steps
1. Remove the two screws (M3) that secure the optional VGA module to the chassis.
2. Disconnect the optional VGA module cable from the connector (VIDEO) on the system board.
3. Slide the optional VGA module out of the port opening and lift the optional VGA module off the system board.
104
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
