3. Align the notch on the wireless card with the tab on the wireless-card slot (M.2 WLAN) on the system board.
4. Slide the wireless card at an angle into the wireless-card slot on the system board.
5. Replace the screw (M2x3.5) to secure the wireless-card to the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Graphics Card
Removing the graphics card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the graphics card and provide a visual representation of the removal procedure.
58 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
