6. Lift the pull tab on the PCIe door outwards to open the PCIe door.
7. Lift the system board at an angle and remove the system board from the chassis.
Figure 86. Removing the system board
Installing the system board
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
The Service Tag of your computer is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program.
You must make the appropriate changes again after you replace the system board.
The following image indicates the connectors on your system board.
110
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
