Steps
1. Lift the pull tab on the PCIe door outwards to open the PCIe door.
2. Remove the PCIe blanking plate from the slot on the chassis.
NOTE: Ensure to keep the PCIe blanking plate safe for future use.
3. Align and place the PS2 and serial module in the PCIe slot on the chassis.
4. Route the PS2 and serial module cable through the routing guides on the chassis.
5. Connect the PS2 and serial module cable to the connector (KB MS SERIAL) on the system board.
6. Close the PCIe door and press it gently until it clicks in place on the chassis, to secure the PS2 and serial module.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Optional HDMI module
Removing the optional HDMI module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the optional HDMI module and provide a visual representation of the removal
procedure.
Figure 76. Removing the optional HDMI module
100
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
