NOTE: This step applies only if you are replacing a M.2 2230 solid-state drive with a M.2 2280 solid-state drive.
2. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot (M.2 PCIe SSD-0) on the system board.
3. At an angle, slide and place the M.2 2280 solid-state drive in the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Dell Ultra Speed Drive Gen3 card
Removing the Dell Ultra Speed Drive Gen3 card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the Dell Ultra Speed Drive Gen3 card and provide a visual representation of the
removal procedure.
Figure 25. Removing the Dell Ultra Speed Drive Gen3 card
50
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
