Table 32. System setup options—Integrated Devices menu(continued)
Integrated Devices
By default, the COM1: Port is configured at 3F8h with IBO4 option is
selected.
USB Configuration
Enable Front USB Ports Enables the front USB ports.
By default, the Enable Front USB Ports option is enabled.
Enable Rear USB Ports Enables the rear USB ports.
By default, the Enable Rear USB Ports option is enabled.
Enable USB Boot Support Enables booting from USB mass storage devices that are connected to external
USB ports.
By default, the Enable USB Boot Support option is enabled.
Front USB Configuration Enables or disables the individual front USB ports.
By default, all the front USB ports are enabled.
Rear USB Configuration Enables or disables the individual rear USB ports.
By default, all the rear USB ports are enabled.
Dust Filter Maintenance Enables or disables the BIOS message for maintaining the optional dust filter
installed in your computer.
When this option is enabled, the BIOS generates a pre-boot reminder to clean or
replace the dust filter based on the interval set.
By default, the Dust Filter Maintenance option is disabled.
Table 33. System setup options—Storage menu
Storage
SATA/NVMe Operation Sets the operating mode of the integrated storage device controller.
By default, the RAID On option is selected. The storage device is configured to
support RAID functions with VMD controller.
Storage Interface Displays the information of various onboard drives.
Port Enablement Enables or disables the individual onboard drives installed on the computer.
By default, all the onboard drives are enabled.
SMART Reporting
Enable SMART Reporting Enables SMART (Self-Monitoring, Analysis, and Reporting Technology) Reporting.
When enabled, the BIOS can receive analytical information from integrated drives
and send notifications during startup about possible future failure of the hard
drive.
By default, the Enable SMART Reporting option is disabled.
Drive Information Displays the information of onboard drives.
Table 34. System setup options—Display menu
Display
Multi-Display
Enable Multi-Display Enables or disables the Multi-Display on the computer.
By default, the Enable Multi-Display option is enabled.
BIOS Setup 121
To Next Page