About this task
The following images indicate the location of the graphics card and provide a visual representation of the installation procedure.
Figure 34. Installing the graphics card
Steps
1. Lift the pull tab on the PCIe door outwards to open the PCIe door.
2. Remove the PCIe blanking plate from the slot on the chassis.
NOTE: Ensure to keep the PCIe blanking plate safe for future use.
3. Align the notch on the graphics card with the tab on the PCIe card connector (SLOT3) on the system board.
4. Gently press down on the graphics card till the tab on the PCIe connector locks in place.
5. Close the PCIe door and press it gently until it clicks in place on the chassis, to secure the graphics card.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
60
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
