Steps
1. Disconnect the data and power cables from the respective connectors on the hard drive.
2. Remove the four screws (#6-32) that secure the 3.5-inch hard drive to the chassis.
3. Remove 3.5-inch hard drive from the chassis.
Installing the 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard drive and provide a visual representation of the installation
procedure.
Figure 36. Installing the 3.5-inch hard drive
Steps
1. Align the screw holes on the 3.5-inch hard drive with the screw holes on the chassis.
2. Replace the four screws (#6-32) to secure the 3.5-inch hard drive to the chassis.
62
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
