Dell P91G - Chapter 45: Replacing the Display Cable; Procedure; Post-Requisites

Removing the display cable
WARNING
: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer. After working inside your computer, follow the instructions in After working inside
y
our computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/
r
egulatory_compliance.
Prerequisites
1 Remove the base cover
.
2 Remove the wireless card.
3 Remove the fan.
4 Remove the heat sink.
5 Remove the display assembly.
6 Follow the procedure from step 1 to step 6 in "Removing the display panel".
7 Remove the camera.
Procedure
1 Peel the tapes that secures the cables to the display panel.
2 Open the latch and disconnect the touchscreen-board cable from the connector on the display panel.
3 Open the latch and disconnect the sensor-board cable from the connector on the display panel.
4 Open the latch and disconnect the display cable from the connector on the display panel.
5 Lift and peel o
 the camera cable from the display panel.
44
Removing the display cable 79