138 Configuring System Information
www.dell.com | support.dell.com
Add ARP Entry Page
3 Select an Interface and define its IP Address and MAC address fields.
4 Click Apply Changes. The ARP Table entry is added, and the device is updated.
Displaying the ARP Table:
1 Open the ARP Setting page.
2 Click Show All. The ARP Table page opens.
ARP Table Page
Deleting ARP Table entry:
1 Open the ARP Setting page.
2 Click Show All. The ARP Table page opens.
3 Select a table entry.
4 Check the Remove check box
5 Click Apply Changes. The ARP Table entry is deleted, and the device is updated.
Configuring ARP Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed
in the ARP Settings page.
To Next Page
Loading...
