210 Configuring Switch Information
www.dell.com | support.dell.com
• Current Port Status—Specifies the port operational status. The possible field values
are:
– Up—Indicates the port is currently operating.
– Down—Indicates the port is currently non-operational.
• Re-Activate Suspended Port—Reactivates a port if the port has been disabled through
the Locked Port or ACL security options.
• Operational Status—Indicates the port operational status.
• Admin Speed—Specifies at what rate the port is running. This value can be specified
only if the port is disabled. The possible field values are:
–10M
– 100M
– 1000M
• Current Port Speed—Specifies the synchronized port speed in bps. The possible field
values are:
–10M
–100M
– 1000M
• Admin Duplex—Specifies the synchronized port duplex mode in bps. When Admin
Duplex is set to full, Head-of-Line blocking is operational on the selected port. The
possible fields values are:
– Full—The interface supports transmission between the device and the client in
both directions simultaneously. This is the default value.
– Half—The interface supports transmission between the device and the client in
only one direction at a time.
• Current Duplex Mode— Specifies the synchronized port duplex mode. The possible
field values are:
–Full
–Half
• Auto Negotiation—Enables Auto Negotiation on the device. Auto-negotiation is a
protocol between two link partners that enables a port to advertise its transmission
rate, duplex mode, and flow control abilities to its partner. The possible field values
are:
– Enable—Enables auto negotiation on the port.
To Next Page
Loading...
