Dell PowerConnect 3324 - Page 219

Configuring Switch Information 219
– Half—The interface supports transmission between the device and the client in
only one direction at a time.
• Flow Control—Indicates if Flow Control is enabled on the LAG. The possible values
are:
– Off—Disables Flow Control on the LAG. This is the default value.
– On—Enables Flow Control on the LAG.
– Auto-negotiation—Enables auto negotiation of Flow Control on the LAG.
• Current Flow Control—Indicates the current Flow Control setting. The possible
values are:
–Off
–On
– Auto-negotiation
Defining LAG parameters:
1 Open the LAG Configuration page.
2 Select a LAG in the LAG field.
3 Define the Description, Admin Status, Port Speed, Admin Auto Negotiation, Admin
Speed, and/or Admin Flow Control fields.
4 Click Apply Changes. The LAG parameters are saved to the device.
Modifying LAG parameters:
1 Open the LAG Configuration page
2 Select a LAG in the LAG field.
3 Modify the Description, Admin Status, Port Speed, Admin Auto Negotiation, Admin
Speed, and/or Admin Flow Control fields.
4 Click Apply Changes. The LAG parameters are saved to the device.
Displaying the LAG Configuration Table:
1 Open the LAG Configuration page.
2 Click Show All. The LAG Configuration Table opens.