Dell PowerConnect 3324 - Page 224

224 Configuring Switch Information
www.dell.com | support.dell.com
Displaying the Port Parameters Table:
1 Open the Storm Control page .
2 Click Show All. The Storm Control Settings Table opens.
Storm Control Settings Table
Configuring Storm Control with CLI Commands
The following table summarizes the equivalent CLI commands for configuring storm
control as displayed in the Storm Control page.
The following is an example of the CLI commands:
Console(config)# port storm-control rate fastethernet 300
Console(config)# port storm-control enable fastethernet
Console# show ports storm-control
PortUnknownBroadcastMulticastRate
CLI Command Description
port storm-control enable
{unknown | broadcast |
multicast} {fastethernet |
gigaethernet interface}
Enables broadcast storm control for
Unicast, Multicast, and Broadcast packets.
port storm-control rate
gigaethernet interface
rate.
Configures the maximum broadcast rate.
show ports storm-control Displays the storm control configuration.