Configuring Switch Information 237
GARP Timers Page
The GARP Timers page contains the following fields:
• Interface—Indicates the type of interface on which GARP Timers are shown. The
possible field values are:
– Port—Indicates the port for which GARP Timers are displayed.
– LAG—Indicates the LAG for which GARP Timers are displayed.
• GARP Join Timer (10–2147483647)—Indicates the time in milliseconds that PDUs
are transmitted.
• GARP Leave Timer (10–2147483647)—Indicates the time lapse in milliseconds that
the device waits before leaving its GARP state. The Leave Time is activated by a Leave
All Time message sent/received, and cancelled by the Join message received. The
default is 600 milliseconds.
• GARP Leave All Timer (10–2147483647)—Used to confirm the port within the
VLAN. The time in milliseconds between messages sent. The default is
10000 milliseconds.
To Next Page
Loading...
