Configuring Switch Information 263
– Admit All—Indicates that both tagged and untagged packets are accepted on the
port.
• Ingress Filtering—Enables Ingress filtering on the port. Ingress filtering discards
packets that are associated with a VLAN that does not include the ingress port. The
possible field values are:
– Enable—Enables ingress filtering on the port.
– Disable—Disable ingress filtering on the port.
Assigning port settings:
NOTE: Ingress filtering can only be disabled on ports set to general VLAN mode.
1
Open the VLAN Port Settings page.
2 Define the Port Mode, PVID, Frame Type, and the Ingress Filtering fields.
3 Click Apply Changes. The VLAN port parameters are defined, and the device is
updated.
Displaying the VLAN Port Table:
1 Open the VLAN Port Settings page.
2 Click Show All. The VLAN Port Table opens.
VLAN Port Table
In addition to the VLAN Port Settings page fields, the VLAN Port Table page also displays
the following field:
• Unit—Indicates the stacking unit number for which the VLAN port information is
displayed.
To Next Page
Loading...
