Dell POWERCONNECT 5548P - Page 193

192 Dell PowerConnect 55xx Systems User Guide
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUGSystemConfig.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the SNTP Interface Settings pages.
Table 9-11. SNTP Interface Settings CLI Commands
CLI Command Description
sntp client enable
{[[gigabitethernet|tengigabitethern
et] port-id|vlan vlan-id|port-
channel LAG-number]}
no sntp client enable
{[[gigabitethernet|tengigabitethern
et]port-number|vlan vlan-id|port-
channel LAG-number]}
Enables the SNTP client on an
interface in Global
Configuration mode.
Use the no form of this
command to disable the SNTP
client.
sntp client enable
no sntp client enable
Enables SNTP client on an
interface in Interface
Configuration mode.
Use the no form of this
command to disable the SNTP
client.
show sntp configuration Shows the configuration of the
Simple Network Time Protocol
(SNTP).